![]() ![]() If you put identical code for the purge line in each process so they build in the same location, then the purge wall is built with 2 different alternating colors, and sometimes there's some really strange stuff Simplif圓D does with this, like making 2 lines at the same Z level at the lowest Z level. This makes the heads need to be primed even more. This means that each process lays down 2 layers before going to the next one. I would expect tool changes to happen for each layer when doing dual extrusion, but they don't, they happen every other layer. ![]() Take a look at the G-code preview in Simplif圓D 2.2.2 and you'll see that Simplify 3D 2.2.2 doesn't do this quite the way you expect it to. It works very accurately for about 98 of the filaments, and is close enough for the other 2. Or you can just use 0.90 for your Extrusion Multiplier and 1.75 mm as your filament diameter. Put this code in the tool change G-code for the appropriate processes. The extrusion multiplier can be changed for each extruder, so you’ll need to use that to fine-tune if you want to. G1 X-50 Y-70 E2 F1200 The value of E is changed by Simplif圓D, but need to be there to draw a line Code: Select all G1 X-10 Y-70 F1200 Move to the start position of a new line ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |